Electrolux Z3300 - Manual (Page 8)

8 7 6 5
4 3 2 1
13
12 11 10 9
English
GETTING THE BEST RESULTS
Use the nozzles as follows:
Carpets: Use the carpet/hard floor nozzle with the lever in
position (1). Reduce suction power for small carpets.
Hard floors: Use the carpet/hard floor nozzle with the
lever in position (2). If you have a carpet/hard floor nozzle
with two pedals – press the pedal on the right (3) to
vacuum up animal hair, etc. more effectively.
Wooden floors: Use the parquet nozzle (certain models
only, 4).
Upholstered furniture: Use the combination nozzle as
shown in (5).
Curtains, lightweight fabrics, etc.: Use the combination
nozzle as shown in (5). Reduce suction power if necessary.
Frames, bookshelves, etc.: Use the combination nozzle as
shown in (6) or Easy clean (7 – certain models only).
Crevices, corners, etc.: Use the crevice nozzle (8).
Using the power nozzle
(Requires an Ultra Silencer equipped with a power socket. The
power nozzle is delivered only with certain models, or could
be bought as an accessory.)
9 Attach the nozzle to the tube.
10 Connect the power nozzle to the socket on the
vacuum cleaner.
11 Use the clips to secure the cable along the tubes and
hose.
12 The power nozzle starts operating when the vacuum
cleaner is switched on.
Using the turbo nozzle
(certain models only)
13 Attach the nozzle to the tube.
Note: Do not use the power or turbo nozzle on skin rugs, rugs
with long fringes or a pile depth exceeding 15 mm. To avoid
damaging the carpet, do not keep the nozzle stationary
whilst the brush is rotating. Do not pass the nozzle across
electric cables, and be sure to switch off the vacuum cleaner
immediately after use.
8
2193277-01.indd 8 7/18/07 4:32:46 PM