Epic Fitness 1000MX - Manual (Page 7)

7
3. Attach the Latch Housing (89) to the Left Upright (90)
with two Latch Bolts (77). Do not overtighten the Latch
Bolts.
3
90
89
77
95
108
86
86
88
99
90
2. Slide the Right Upright (95) fully onto the bracket on the
Base (99). Be careful to avoid pinching your hands or
the Upright Wire Harness (108).
Attach the Right Upright (95) with four Upright Bolts (86)
and two 3/8” Star Washers (88) as shown. If necessary,
adjust the position of the Right Upright to align the Upright
Bolts with the holes.
Do not tighten the Upright Bolts
yet. Attach the Left Upright (90) in the same way. Note:
There are no wires on the left side.
2
4. Remove the elastic band securing the Upright Wire
Harness (108). Have two persons hold the console as-
sembly near the Left Upright (90) and the Right Upright
(95). Connect the Upright Wire Harness to the Console
Wire Harness (A).
Make sure to connect the connec-
tors properly (see the inset drawing); the connectors
should slide together easily and snap into place. If
the connectors do not slide together easily and snap into
place, turn one connector and try again to connect them.
IF THE CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON.
Insert the Wire Harnesses (A, 108) into the Right Upright
(95). Next, insert the front ends of the brackets on the
console assembly into the Right Upright and the Left
Upright (90). Then, insert the back ends of the brackets
into the Uprights.
Make sure that the Wire Harnesses
are not pinched.
95
Console
Assembly
Front of Bracket
90
A
108
4
108