Escient FIREBALL DVDM-100 - Manual (Page 22)

PAGE 22
FireBall™ DVDM-100 User
’s Manual
Connecting Sony CD Changers
FireBall requires that you connect each changer to the back panel using audio and control cables.
Follow these steps to connect your Sony CD changers to your FireBall:
1. Locate the included S-Link cable. This is the 10’ black cable with 1/8” male plugs on each end.
2. Connect one end of the S-Link cable into the S-Link/IR Out jack number 1 on the back of your FireBall.
3. Connect the other end of the S-Link cable into the Control A1 jack on the back of your changer.
4. Locate the stereo RCA audio patch cable that came with your changer.
5. Connect one end of the RCA audio cable into the Analog In jacks number 1 on the back of your FireBall
6. Connect the other end of the RCA audio cable into the Analog Line Out jacks on the back of your changer.
7. If your changers has a “Command Mode” switch on the rear panel, make sure the is set to 1 for all changers. If no rear
switch, use the changers menu to set it to CD1 for all changers.
• If you have more than one changer, repeat these steps to connect the additional changers to S-Link and audio jacks 2 and 3 respectively.
• For the best audio quality, you should also connect digital optical or coax audio cables (not included) between your changers and FireBall.