Electrolux ER 7628 B - Manual (Page 5)

5
OPERATION
Before using
Remove all securing tapes. Wash inside the
appliance with lukewarm water and bicarbonate of
soda (5 ml to 0.5 litre of water).
Do not use soap or detergent as the smell may
linger. Dry thoroughly.
Temperature control
The temperature within the appliance is controlled by
the thermostat situated at the top of the cabinet.
To operate the appliance proceed as follows:
Turn the thermostat control beyond the З
■ И position.
When you first start the appliance, we suggest that
you turn the thermostat control to a medium setting,
although the temperature will be affected by:
- Room
temperature
- How often the door is opened
- How much food is stored
- Position of the appliance
In determining the correct temperature control
setting all these factors have to be considered and
some experimentation may be necessary.
When altering the temperature setting, allow 24
hours for the temperature to stablise before making
further changes
To obtain a lower temperature, turn the thermostat
control towards max; to obtain a higher temperature
turn the control towards min. For easier turning of this
control, use a small coin.
The freezer compartment
The four-star freezer compartment is suitable for
storage of commercially frozen food and for freezing
fresh foods.
Freezing fresh food
It is not necessary to adjust the thermostat setting
when freezing fresh food.
In any 24 hours you can freeze up to 4 kg.
Place food to be frozen in the upper drawer of the
freezer as this is the coldest part.
Important
In the event of a power cut the food in the freezer will
not be affected if the power cut is short and if the
freezer is full. Do not open the door. Should the food
begin to thaw, it must be consumed quickly and must
not be re-frozen .
Control panel
min max
A B C D
ON
A. Pilot light for ambient temperature switch
B. Ambient temperature switch C. Operating pilot light
D. Thermostat knob
Starting your appliance
Insert the plug into the wall socket.
The thermostat switch (D) will pre-set and the
operating pilot light (C) will illuminate.
If the Thermostat switch is in the OFF (
■ ) position,
use a coin to turn the switch to a medium setting and
the operating pilot light will illuminate.
Ambient Temperature Switch
With a room temperature below + 16¡C the
refrigerator compartment may not function correctly.
If the room temperature is lower than + 16¡C it will
be necessary to press switch (B).
The relevant pilot light (A) comes on.
20
Door reversal directions
1. Disconnect from the electricity supply.
2. Gently lay the fridge/freezer on its back with the
top held away from the floor by 5-8 cm (2-3
inches) of packing;
3. Remove the ventilation grill (D).
4. Unscrew the bottom hinge (E).
5. Remove the freezer door by releasing it from the
middle hinge (H).
6. Unscrew the middle hinge.
7. Remove the fridge door by releasing it from the
top hinge pin (G).
8. Remove the pin then mount these on the side,
after having removed the small plugs which
should then be fitted on the opposite side.
9. Refit the fridge door and replace the middle hinge
to the left hand side.
9. Replace the door and bottom hinge (E) on the
opposite side.
10.Remove the plug (F) from the ventilation grill (D)
and replace it on the opposite side. Re-assemble
the ventilation grill (D).
11.Unscrew the handles. Refit them on the opposite
side after having pierced the plugs with a punch.
Cover the holes left open with the plugs
contained in the documentation pack.
The doors can be aligned by adjusting the middle
hinge.
The middle hinge can be adjusted horizontally, after
having slackened the two screws with a screwdriver.
Important
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdrier on a low setting.
G
H
PR228
E
F
D
F
F
F
Printed on recycled paper