OPHIT DQSL - Manual (Page 5)

Installation
Function Switch
Installation
1. Connect a source device to DVI input port on DQSL Transmitter.
2. Connect 2ch of LC type optic fiber cables to optical port.
3. Connect the display device to DVI output port on DQSL Receiver.
4. Connect UTP cable between TX and RX for DDC communication. (Optional)
5. Plug the power adapter to both Transmitter and Receiver.
4 www.ophit.com
EDID Switch in front of Transmitter
-
REAL : EDID data of connected monitor is transmitted betweeb Tx and Rx in real
time through UTP cable.
- Emulation : Certain EDID data pre-set in the Tx is used in signal transmission.
UTP cable is not necessary.
MODE Switch in front of Transmitter
-
Single : When you use Single link display, select ‘Single’ switch.
- Dual : When you use Dual link display, select ‘Dual’ switch.