Mpman RPV100 - Manual (Page 4)

To turn on the system ‘on’, press the POWER button at back side of the
unit and set the volume to a low level, the tuning dial light comes ‘on’.
Press the function buttons(AM/FM) for desired band, AM or FM.
Rotate the TUNING control to the desired radio station.
Adjust the VOLUME control as desired.
When you have finished listening, press the POWER button again. The
tuning dial light goes ‘off’.
FM - The FM antenna is the rod at the top of the cabinet. If FM reception is
unsatisfactory, try adjusting the rod at any direction till the reception is good.
AM - The AM bar antenna is inside the cabinet. If AM reception is
unsatisfactory try repositioning the cabinet slightly until the internal antenna
is picking up the strongest signal.
4
Battery Operation
The unit can be operated by DC, you may put 6pcs batteries(UM-2 “C” R14 2#
DC1.5V, not include.) into the battery compartment on the bottom of the cabinet.
The function is the same as that of AC power.
Battery Compartment
Note: The DC/VOLUME button
can control the DC power turn on or turn off