Mpman FRA200 - Manual (Page 6)

Press the DISPLAY button changing the display as shown below.
1. In the Standby mode : `ALARM 1` display >> `ALARM 2` display >> Clock display.
2. In the Radio mode : Radio frequency >> `ALARM 1` display >> `ALARM 2` display >> remain time
of SLEEP Timer >> Clock display.
Stopping & Resetting the ALARM
Press the POWER/ALARM RESET button once to stop the sound of the `ALARM 1` or `ALARM 2` and it will
automatic activate after 24 hours.
Snooze operation
The SNOOZE function will temporarily switch off the alarm for approximately 9 minutes, this is repeatable for
a duration in one hour of alarm cycle.
ALARM off
Alarm active - press the POWER/ALARM RESET or SNOOZE button to stop the sound first. Then, press the
ALARM 1 or ALARM 2 button till the ALARM indicators light off.
Alarm non-active - press the ALARM 1 or ALARM 2 button till the ALARM indicators light off.
Weekend Sleep function
When the Alarm is under non-active mode, Press the SNOOZE/ WEEKEND BUTTON to enable /disable
weekend sleep function. If weekend sleep function is on, alarm will not function on SAT and SUNDAY even
though the alarm timer is enabled and the time is matched.
Operating the Alarms
Display Mode setting
9
If your product is fitted with a moulded plug which
requires replacement please cut off the plug and
dispose of safety.
The replacement plug should then be rewired as
shown in diagram.
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:- BLUE NEUTRAL
BROWN-LIVE
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloure
d markings identifying the terminals in your plug, proceed as followings:-
The wire which is coloured blue must be connected to the terminal which is marked with the letter
N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter
L or coloured red.
No connection is to be made to the earth terminal of the plug.
If a 13 AMP (BS 1363) Plug is used a 3 AMP Fuse must be fitted, or if any other type of Plug is used
a 3 OR 5 AMP Fuse must be fitted, either in the Plug or Adaptor, or on the Distribution Board.
BLUE
(NEUTRAL)
N
OUTER
SLEEVE
FUSE
BROWN
(LIVE)
L
CORD GRIP