Mpman FRA300 - Manual (Page 2)

Audio Output Integrated Speakers
Power Supply AC~230V, 50Hz
Backup Battery DC 9V
Specifications and manual are subject to change without prior notice.
The FRA300 does not turn on.
Make sure the unit has been powered on manually.
Ensure that the power cord has been properly connected to the power outlet
and the power supply is AC~230V 50HZ
•
•
There is no sound.
Ensure that the volume of FRA300 and or external device has been set to a
reasonable level
•
•
Lightning: For added protection for this product, unplug it from the wall outlet and discon-
nect the antenna or cable system during a lightning storm or when it is left unattended
and unused for long periods of time. This will prevent damage to the product due to
lightning or power-line surges.
Power Lines: An outside antenna system should not be located in the vicinity of over-
head power lines or other electric light or power circuits, or where it can fall into such
power lines or circuits. When installing an outside antenna system, extreme care should
be taken to keep from touching such power lines or circuits, as contact with them might
be fatal.
Overloading: Do not overload wall outlets, extension cords, or integral convenience
receptacles as this can result in a risk of fire or electric shock.
14.
15.
16.
Object and Liquid Entry: Never push objects of any kind into this product through open-
ings as they may touch dangerous voltage points or shout-out parts that could result in
a fire or electric shock. Never spill liquid of any kind on the product.
Servicing: Do not attempt to service this product yourself as opening or removing covers
may expose you to dangerous voltage or other hazards. Refer all servicing to qualified
service personnel.
Damage Requiring Service: Unplug this product from the wall outlet and refer servicing
to qualified service personnel under the following conditions: a) when the power-supply
or plug is damaged; b) if liquid has been spilled or if objects have fallen into the product;
c) if the product has been exposed to rain or water; d) if the product does not operate
normally by following the operating instructions. Adjust only those controls that are cov-
ered by the operating instructions as improper adjustment of other controls may result
in damage and will often require extensive work by a qualified technician to restore the
product to its normal operation; e) if the product has been dropped or damaged in any
way; f) when the product exhibits a distinct change in performance—this indicates a
need for service.
Replacement Parts: When replacement parts are required, be sure that your service
technician has used replacement parts specified by the manufacturer or have the same
characteristics as the original part. Unauthorized substitutions may result in fire, electric
shock, or other hazards.
Safety Check: Upon completion of any service or repairs to this product, ask the service
technician to perform safety checks to ensure that the product is in proper operating
condition.
Wall or Ceiling Mounting: The product should be mounted to a wall or ceiling only as
recommended by the manufacturer.
Heat: The product should be situated away from heat sources such as radiators, heat
registers, stoves, or other products (including amplifiers) that produce heat.
17.
18.
19.
20.
21.
22.
23.
Make sure the external device has been properly connected to FRA300 by
audio cable.
Troubleshooting
Specifications
Frequencies
Power Consumption 5W
Double insulation
This is a class II apparatus
The marking is located on the bottom enclosure.
The mains plug is used as disconnect device, the disconnect device should remain readily operable.