Mpman TCD600 - Manual (Page 7)

6
Bluetooth operation
1. Press the MODE button to switch to the Bluetooth mode.
2. The previous paired device will connect to speaker tower automatically
when each time changing to Bluetooth mode.
3. Turn on the Bluetooth device (e.g. phone) and enter the Bluetooth search
interface.
4. Search "MP720" and pair it, input the password "0000" if necessary. Then
the indicator will light steadily.
5. If it still doesn't work, reset the Bluetooth and follow above steps again.
NFC operation
1. Press the MODE button to enter the Bluetooth mode.
2. Place the back of phone (with NFC function) on the position of word
“ NFC”
on the front panel of the unit for 3 seconds, the Bluetooth function of the
phone is activated automatically.
3. When the indicator lights steadily and you can hear an audible signal, they
are paired.
4.To disconnect NFC Bluetooth connection, place the back of the phone on
the position of the word “ NFC” on the front panel of the unit. When there
comes an audible signal, they are disconnected.
5. Some devices of Android system 4.0 or below need to install the NFC.apk
to enable the NFC function. Some devices may be in a weak compatibility
for NFC function, that may relate to the NFC software.
USB
5V1A FOR CHARGE
NFC
NFC sensor Phone with NFC
USB operation
1. Power on the unit and insert a USB Flash Drive (not supplied) into the
USB Port, ensuring the plug is fully inserted at the correct way.
2. Press the MODE button to switch to the USB mode.
3. The tower will play music from the USB automatically.
4. The maximum size of Flash Drive that can be connected is 32GB max.