Energizer Air Quality Computer User Manual
Page 7
6
SAMPLE AIR
By pressing "1" from the MAIN menu the unit displays all the sampled
air parameters and the PREDICTION in the following format:
DATE
TIME
TEMP
HUMIDITY
PRESSURE
OXYGEN (if equipped) / DEW POINT VAPOR PRESSURE
ALTITUDE/CF PREDICTION (ET or TS)
Pressing the “ENTER” key while viewing current data will HOLD the
data to be used for entering runs. The third and fourth line on the display
will alternate from showing pressure and oxygen to dew point and vapor
pressure and Altitude to Correction Factor (CF).
NOTE: Barometric Pressure
The Pressure reading is “Absolute”, which means it will NOT agree with
the weather channel or local forecast. This is due to the fact that the
local forecast is gives a corrected pressure reading that is compensated
back down to sea level. If you were to stand at your local airport and dig
a hole down to sea level the
PerformBJSF pressure reading would then
agree with the local airport reading!
The PREDICTION Multiple Run Mode will be shown only after two
runs in ET mode and three runs in TS mode have been stored in the
selected data base. If less runs have been stored "***" will appear in the
place of the PREDICTION value.