Extron electronic MTP T 15HD A AAP - Manual (Page 8)

VersaTools ® MTP 15HD A Series • Installation VersaTools ® MTP 15HD A Series • Installation
VersaTools ® MTP 15HD A Series, cont’d
VersaTools ® MTP 15HD A Series • Installation VersaTools ® MTP 15HD A Series • Installation
MT P T VG A R S
MT P T VG A R S MT P T VG A R S
Figure 2 — Mounting the MTP on a standard shelf
On the non-VersaTools rack shelves, the MTP can be mounted in
the front or the rear of the rack.
1 . Remove the feet from the bottom of the MTP if they are
already installed.
2 . Mount the MTP using two 4-40 x 3/16" screws in opposite
(diagonal) corners to secure the MTP to the shelf.
3 . Install false faceplate(s) or other unit(s) to the rack shelf.
4 . Insert the shelf into the rack, aligning the holes in the shelf
with those of the rack.
5 . Secure the shelf to the rack using the supplied machine
screws (figure 2).
9 8
Back of the rack mounting instructions
The MTP can be mounted to the rear of a rack using the Extron
MBB 100 VersaTools back of the rack mounting kit
(part #70-367-01) (figure 3). The kit allows the product to be
vertically mounted to the front or rear rack supports and facing
either towards the front or the rear of the rack.
M T P S E R I E S
Figure 3 — Attaching the back of the rack kit
1 . Remove the feet from the bottom of the MTP if they are
installed.
2 . Remove the two screws from one side of the unit. Retain
the screws for possible later reassembly without the
bracket.
3 . Attach one bracket to the side of the unit using the longer
screws included in the kit.
4 . Repeat steps 2 and 3 on the other side of the unit.