Extron electronic MTP T 15HD A AAP - Manual (Page 9)

VersaTools ® MTP 15HD A Series • Installation VersaTools ® MTP 15HD A Series • Installation
VersaTools ® MTP 15HD A Series, cont’d
VersaTools ® MTP 15HD A Series • Installation 10
5 . Mount the unit to the rack using the two included rack
screws (figure 4). The MTP can be vertically mounted
facing in either direction.
IN
P U T A U D IO
M O N IT O R
P O W
E R
1 2 V .5 A M A X
O U T P U T
MTP T
15HD
A
P R E -P E A K
O N
O FF
MA V S ER IE S
AV M AT RIX SW ITC HE R
I/O
AU D
AU DIO SE TU P
PR ES ET
VID
IR
+dB
-dB
EN TER
2
7
6
5
2
4
1
INP UT S
OU TP UT S
8
3
1
8
6
5
4
3
7
MTP SERIES
Rear
Front
Figure 4 — Typical back of the rack installations
Furniture or projector mounting
Use one of the following optional mounting kits to mount the
MTP under furniture or to a projector mount (figure 5).
• MBU 123 VersaTools under desk mounting kit,
part #70-212-01
• PMK 100 VersaTools mini projector mounting kit,
part #70-217-01
1 . Remove the feet from the bottom of the MTP, if they are
installed.
2 . Attach the mounting brackets to the MTP with the
provided machine screws.
3 . For furniture mounting , hold the MTP with the attached
brackets against the mounting surface. Mark the bracket
screw hole locations on the mounting surface.
4 . For furniture mounting , drill 3/32" (2 mm) diameter pilot
holes, 1/4" (6.3 mm) deep in the mounting surface at the
marked screw locations.
Projector
Projector
Mounting
Bracket
Mounting
Bolt
PRE-PEAK ON OFF
IN P U T
O U T P U T
P O W E R 1 2 V .5 A M A X
T x
R x R S -2 3 2
M T P R 1
5 H D R
S
O N 1 2 3 4 5 6 H S YN C + V S YN C + C S YN C SO G VID EO SP AR E
M T P S E R I E S
Figure 5 — Desk and projector mounting the MTPs
5 . For furniture mounting , insert #8 wood screws into the
four pilot holes. Tighten each screw into the mounting
surface until just less than 1/4" (6 mm) of the screw head
protrudes.
6 . For furniture mounting , align the mounting screws with
the slots in the brackets and place the MTP against the
surface, with the screws through the bracket slots.
7 . For furniture mounting , slide the MTP slightly forward or
back, then tighten all four screws to secure the MTP in place.
8 . For projector mounting , secure the MTP to a projector
mount by inserting the mounting bolt through the
bracket’s slotted hole and tightening the bolt.
11