Amprobe MO-100 Milliohm-Meter - Manual (Page 16)

12
MAINTENANCE AND REPAIR
If there appears to be a malfunction during the operation of the meter, the
following steps should be performed in order to isolate the cause of the
problem.
1. Check the battery. Replace the battery immediately when the symbol
“N” appears on the LCD.
2. Review the operating instructions for possible mistakes in operating
procedure.
Except for the replacement of the battery, repair of the meter should be
performed only by a Factory Authorized Service Center or by other qualified
instrument service personnel.
The front panel and case can be cleaned with a mild solution of detergent and
water.
Apply sparingly with a soft cloth and allow to dry completely before using. Do
not use aromatic hydrocarbons, Gasoline or chlorinated solvents for cleaning.
BATTERY REPLACEMENT
1. Disconnect the test leads from the instrument and remove the battery
cover and the batteries.
2. The tester’s battery is situated under the tester.
3. Replace with eight 1.5V AA light batteries, taking care to observe
correct polarity. (Alkaline batteries are recommended.)
4. Reinstall battery holder and the battery cover.