Archelon CAS - Manual (Page 2)

Archelon Enclosures, 2200 Cleveland Avenue, National City, CA 91950
www.ArchelonEnclosures.com
Instructions For Mounting to Dry Wall
Step 1. Drill ¾ bit Holes into Drywall using the CAS Base to place the holes.
Step 2. Insert Togglers into each hole.
Step 3. Push zip cap flush with surface.
Step 4. Snap off legs of the toggle flush with your surface.
Step 5. Place Wall Mount up to the holes.
Step 6. Using a 7/16 Ratchet (Not Supplied) - ratchet the 7/16” bolt with Supplied 5/8” washers
into the holes.
Step 7. Place decorative caps over bolt holes
Instructions for Attaching to a Wood Stud
Step 1. Locate Wood Stud
Step 2. Drill 1/8” Pilot Holes into stud using the CAS Base to place the holes
Step 3. Using a 7/16” Ratchet (tools not supplied) – ratchet the Lag Screws (x2) into Pilot Holes
until Wall Mount is snug to the Surface.
Step 4. Place decorative caps over bolts holes
Note: 1 5/8” Washers are for leveling surfaces that are not flat or for custom applications.