Earthquake Sound XJ-300 FR - Manual (Page 14)

14 XJ-300FR Manual Earthquake Sound Corp. | www.earthquakesound.com
Connecting to Tactile Transducers
Make sure the front toggle switch is set to “Low Pass” if
connecting to a subwoofer or tactile transducer.
Note:
Wiring with 2 MQB-1 Tactile Transducers
Receiver/Processor
+ _ + _
Do not wire 1 MQB-1
with the mono bridge
setting. Use either the
left or right speaker
output.
Connecting to Outdoor Speakers
Make sure the front toggle switch is set to “Bypass” if
connecting to speakers or a 2.1 channel system.
Note:
Receiver/Processor
Wiring with AWS All Weather Speakers
+ _ + _
AWS 602 or AWS 802
This may overload the
speakers. Be sure to
not set the volume too
high.