beautypg.com

How to maintain, Brush roll belt and headlight, How to replace worn belt or headlight bulb – Eureka BUILT-IN CV200 User Manual

Page 7

background image

7

HOW TO MAINTAIN

The instructions given in this booklet serve as a guide to routine maintenance. To
avoid unnecessary service calls check the belt and brush roll often. Replace the belt
if it is stretched or cracked and clean the brush roll bristles when they are wrapped
with thread and hair.

Brush Roll Belt and Headlight

The brush roll belt on the motorized nozzle drives the brush roll to agitate, sweep, and
comb the carpet nap. The belt should be checked regularly to be sure that it is in
good condition. Replace the belt if it is stretching, cracking, or slipping. Cut away any
hair or thread wound around the brush roll or belt pulleys because the buildup could
cause the belt to rotate unevenly.

How to Replace Worn Belt or Headlight Bulb

NOTE: Disconnect power cord and wands from electrical hose before

replacing belt or bulb. Belt pulleys can become hot during normal
use. To prevent burns, avoid touching the belt pulley when servicing
the drive belt.

1. Remove two screws from bottom

side. Turn over to grasp hood by
handle socket and lift forward.

Replace headlight bulb, if
necessary. Use GENUINE
EUREKA 25 watt replacement
bulb 40009A.
Continue to step
2 to change belt. Skip to step 7
and 8 to replace hood on
motorized nozzle.

3. Lift out brush roll; replace new

belt around brush roll pulley.

5. Rotate belt onto motor pulley.
6. Replace brush roll cover.

7. Tilt cover over ridge and push down.
8. Secure with screws on underside

(refer to 1).

2. Remove two screws located in

front of the light bulb and lift up
to remove the brush roll cover.

4. Return brush roll into base.

Look for the symbol.

Use GENUINE EUREKA

replacement belt, 52201A.

GENUINE

EUREKA PRODUCT

Motor

Pulley

Ridge

This manual is related to the following products: