DE DIETRICH DFS914JE - Manual (Page 8)

Problem Possible cause Solution
The appliance does not
operate. The Pilot light
does not flash. The appliance is switched off. Switch on the appliance.
The mains plug is not connected
to the mains socket correctly. Connect the mains plug to the
mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket. Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
The Pilot light flashes. The appliance is not working
properly. Contact a qualified electrician.
The buzzer sounds. The
Alarm light flashing. The temperature in the freezer is
too high. Refer to "HighTemperature Alarm".
The door is not closed correctly. Refer to "Door open alarm".
The compressor operates
continually. The temperature is not set cor-
rectly. Set a higher temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently. Do not keep the door open longer
than necessary.
The product temperature is too
high. Let the product temperature de-
crease to room temperature before
storage.
The room temperature is too
high. Decrease the room temperature.
The Auto Freeze function is
switched on. Refer to "Auto Freeze function".
The temperature in the
freezer is too low. The temperature regulator is not
set correctly. Set a higher temperature.
The Auto Freeze function is
switched on. Refer to "Auto Freeze function".
The temperature in the
freezer is too high. The temperature regulator is not
set correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high. Let the product temperature de-
crease to room temperature before
storage.
Many products are stored at the
same time. Store less products at the same
time.
Products are too near to each
other. Store products so that there is cold
air circulation.
There is too much frost. Food is not wrapped correctly. Wrap the food correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not
set correctly. Set a higher temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Force Cen-
ter.
34