DE DIETRICH DVH1200JU - Manual (Page 3)

3
3.3 Detergent. You can use tablets, powder
or liquid. The amount to be used is
detailed in the progammes table. Pour
the required dose into the compartment
located inside the door (3.3.1) and close
the lid. In programmes that require an
additional dose, place it on top of the lid
(3.3.2).
3.4 Switching on (with the door open) .
3.5. Checking salt and rinse aid levels.
Salt. If the pilot light is lit up, you
have to fill the compartment. You should
not use salt if you do not need it (note
in section 2.2). If you do need it, follow
the steps explained in section 2.3, but fill
the compartment completely with salt.
If your appliance does not have a
warning light, you should fill the salt
compartment up after every 20 washes
for medium-hard water.
Rinse aid. If the pilot is lit or the
indicator light (3.5.1) inside the door is a
light colour, always refill until the
compartment is completely full (3.5.2).
3.6 Programme Selection. Programme
selection using the PROG button (2.2.10)
On display models (type B), the selected
programme will appear (P1, P2, etc.)
3.7 Selecting options.
All in 1 detergent (A type models
only)
Hold down the and OPC buttons
simultaneously for more than 3 seconds
(3.7.1).
If you use ALL-IN-ONE detergents, the
washing or drying results (and the times)
may be negatively affected, mainly in the
case of short and/or low temperature
programmes.
It is important to read the instructions on
the packet (3.3.3).
If in doubt, consult the detergent
manufacturer.
Time reduction
Shortens washing and drying times. This
can be used for the Intensive, Normal or
Automatic, Hygienizer and Economy
Programmes
Top/bottom load (duo-zone) .
Uses half of the dishwasher capacity. Top
basket , Bottom basket , or both.
Half Load (1/2)
This is the same as Top Load (only the top
basket is used)
Any change of programme will deactivate
options that are not compatible.
3.8 Delay Timer
Allows you to delay the Dishwashing start
time. Press the key several times until you
see the delay required on the screen (3.8.1)
or pilot (3.8.2).
If you want to cancel the delay, press .
3.9 Start-up
For A type models, press the button
(2.2.6) and close the door. For other
models, simply close the door.
For all models, when you close the door a
programme start beeper will sound.
After the programme has started, if you wish
to change the programme or option, open
the door carefully (there is a risk of
splashes) and restart the dishwasher .
3.10 Dishwashing process.
If there is a power cut during the
programme, once the power has been
restored, the dishwasher will continue to
operate normally from the same point at
which it stopped.
It is not advisable to open the dishwasher
door while it is in the process of washing.
Results could be affected. If you do, watch
out for hot water splashing out.
3.11 End of programme. When the programme
ends, the appliance will emit a beep and the
END (STOP) pilot light will come on, if your
model has one..
Switch off the machine . It will contribute
to energy saving.
3.12 Warnings about use.
Avoid having the door open to avoid
accidents (3.12.1).