DE DIETRICH DHD1100X - Manual (Page 10)

31
4/ CLEANING THE HOOD EN
Careful maintenance helps guarantee proper operation and good results from an appliance
over time
The hood must be unplugged from the electrical power source, both by unplugging
the appliance from the socket as well as de-activating the breaker, before removing the
metal filters. After cleaning, you must replace the metal filters as outlined in the instruc-
tions..
MAINTENANCE HOW TO PROCEED? ACCESSORY/PRODUCTS TO USE
External surfaces
and
accessories
Do not use metallic scrubbers,
abrasive products, or hard
brushes.
To clean the external surfaces of the
hood and the light housing screen
use only commercially available
household detergents diluted in wa-
ter. Then rinse with clean water and
dry with a soft cloth.
Filter cartridge
After 30 hours’ operation, the
button pad will signal that the
grease filter is saturated by
flashing the 4 speed LEDs.
Press the timer button to re-
set .
The grease filters can be washed by
hand or in the dishwasher. These fil-
ters need to be cleaned on a regular
basis because otherwise they may
present a fire risk. Refit the grease
filters and front panel, making sure
that the panel is properly fitted at the
sides so that it does not cause the
downdraft to stop operating.
Carbon filter
In the recirculation mode, you
must substitute the active
carbon filter periodically.
To remove the fibre panel you
must first remove the anti-
grease grill and pull the plas-
tic knob on the panel itself,
removing it from its housing.
To replace the active carbon
filter, do the reverse. Replace
the used carbon filter on an
average of every six months.
OTHER FUNCTIONS:
• After 30 hours of appliance operation, the pushbutton panel indicates saturation of the
grease filters by the buttons flashing. To reset, press the timer button .
• After 4 hours of continuous operation from the last setting, the appliance turns off and
closes automatically.
• When the front panel is removed for cleaning and maintenance operations, all the elec-
tronic aspiration and movement functions are locked.
• Anti pinching safety device: if anything is obstructing the closure operation of the down-
draft, the operation will stop and the downdraft will move up again.