Emerson CF705BS03 - Manual (Page 3)

1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One switch housing assembly
c. Five fan blades
d. One ceiling cover
e. Five blade flanges
f. One hanger ball/downrod assembly
g. One hanger bracket
h. One loose parts bag containing:
1. Sixteen 3/16-24 x 1/4” slotted Phillips
blade screws
2. Sixteen blade washers
3. Eleven 1/4-20 x 1/2” Phillips oval head
flange screws
4. One wood pendant
5. One coupling
6. Three wire connectors
7. Two threaded studs
8. Two lockwashers
9. Two knurled knobs
10. One clevis pin
11. One hairpin clip
This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver One stepladder
One 1/4” blade screwdriver One wire stripper
One 5/16” open end wrench, or pliers
Three wire connectors (supplied).
MATERIALS
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be
a 3-conductor (2-wire with ground) of following size :
3
Installed Wire Length Wire Size A.W.G.
Up to 50 ft. 14
50-100 ft. 12
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is completed,
place a check mark in the box. This will insure that all steps have been completed and will be helpful
in finding your place should you be interrupted.
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local retail-
er or catalog outlet for replacement before
proceeding.
2. Remove the fan assembly from the protective plas-
tic bag. Place the fan assembly into the upper
foam pad with the top of the motor facing up.
The upper foam pad serves as a holder for the fan
during the first stages of assembly.
SWITCH CUP
ASSEMBLY
COUPLING
COVER
LOOSE PARTS
BAG
FAN MOTOR
ASSEMBLY
HANGER
BRACKET
FAN
BLADES
BLADE
FLANGES
CEILING
COVER
HANGER BALL/
DOWNROD
ASSEMBLY
Before assembly your ceiling fan, refer to section on
proper method of wiring your fan (page 6). If you feel
you do not have enough wiring knowledge or experi-
ence, have your fan installed by a licensed electrician.
WARNING !
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Company. Substitution of parts or acces-
sories not designated for use with this product by
Emerson Company could result in personal injury or
property damage.
WARNING !
WARNING !