Roth AV DBT-001 : FM/DAB+ Radio with Bluetooth Receiver - Manual (Page 9)

rothaudio.co.uk
|
9
User Manual
English
Activating the alarm function
1. To activate the alarm function, press the ALARM button to enter into the Alarm Menu and select Alarm (1 or 2).
2. Rotate the Ok control followed by pressing on the same control to select “Alarm Source”.
3. Again rotate the Ok control and the associated alarm wake-up mode will be displayed and changed in the below sequence:
4. When the display shows your desired alarm wake-up mode, press the Ok control, the alarm function is now activated and the associated
alarm icon will be displayed.
5. When the alarm time arrives, the selected wake-up mode will be on and the alarm icon in the display will flash to indicate the alarm is
triggered. To stop the alarm sooner, press the button.
Note 1: If you have activated the alarm function and the wake-up mode is DAB or FM, make sure that the alarm volume level is set at a
sufficient level for you to hear.
Note 2: The alarm comes first will have the priority and it would continue for a duration of one hour, the snooze will just switch off this alarm
temporary during this duration, so if the second alarm comes in this period, it will not function. But if the first alarm is switched off before the
second alarm arrives, then the second alarm will be activated.
Automatic Alarm Repeat
The alarm will automatically repeat each day at the selected time as long as the alarm icon is displayed. To cancel this function, go to the
Alarm Menu and select “Alarm # off” in the associated “Alarm Source” menu.
Snooze function
When the alarm has triggered, press the SNOOZE button will temporary switch off the alarm for 5 minutes, the display will show “ Zz ” to
indicate snooze on. This is repeatable in the one hour alarm duration.
Sleep Function
This function allows you to program the radio to switch off itself after a set period of time.
1. To activate the sleep function, repeatedly press the SLEEP button, the display will show “Sleep Timer” and the time will change in the
below sequence on every press: 90 > 80 > 70 > 60 > 30 > 10 > Off > 90 > 80 > …
2. When your desired sleep time appears in the display, release the button and the sleep function will be activated in two seconds. The
display will show “s#” where “s1” is to represent “10 minutes” sleep time and so on.
3. When the sleep time counts to zero, the unit will go off. To put the sleep function off during sleep timer on, repeatedly press the SLEEP
button until the display shows “Sleep Timer Off”.
4. To check the sleep timer status, press the SLEEP button once.
Alarm #Off DAB Preset # FM Preset # Buzzer Tone #
DBT-001 Manual VJ.indd 9 7/8/12 13:23:15