Elta 9095N5 - Manual (Page 6)

9
10
SAFETY
INSTRUCTIONS
•
The safety guard (3) must be in faultless condition at any time.
•
Do not put any objects into the safety guard or the air inlet openings (4).
The safety guard and the air inlet openings may not be covered
during operation.
•
Small children, children and older persons should not be exposed to the cold stream of air for continuous time.
•
Do not use the device in very hot or damp surroundings (e.g. bathroom or toilet).
•
Unplug the mains plug from the electrical outlet before cleaning or disassembling.
•
Never operate the device without pedestal or in a lying position.
•
Keep loose objects like plants, curtains, etc. away from the device.
•
Connect the device to power supply only after it is completely assembled.
INTENDED USE •
This device is only meant for private domestic use and has to be used as a fan to circulate the room air
.
The device is not intended for
commercial or industrial use.
PRIOR T
O
FIRST USE
•
Remove all packaging materials.
•
Clean the appliance, as described in
Cleaning and Care
. Dry all parts
carefully before using them.
ASSEMBL
Y
•
Put the tower fan on a flat surface (e.g. a table) so that the base part (1
1) points to you. For the following assembly steps see Fig. 2.
•
Put the back pedestal part (12) on the 2 cam levers in the base part; the power cord (6) must be placed in the middle of the base part.
•
Put the power cord into the cut-out of the back pedestal part and on the cable guide (13). Fasten the power cord with the cable support (14) and the Phillips screws (15).
•
Put the front pedestal part (17) on the base part. Put the front pedestal part on the cable guide in the base part as well as the cam levers at the back base part.
•
Fasten the front pedestal part with the Phillips screws (18) in the openings at the front pedestal part (16.)
•
Now set the tower fan vertically
. It is ready for use.
GB GB
OPERA
TION
•
Connect the mains plugs (6) with a proper electrical outlet.
•
Open the cover (1). Push the level buttons 1 / 2 / 3 (9) to switch on the device and select the desired level. 1 = low speed 2 = middle speed 3 = high speed
•
Push the of
f button (8) to switch of
f the device.
Oscillation •
Push the oscillation button (7) for swinging from left to right.
T
o
keep
the air stream at certain position push the oscillation button again at the desired position.
T
imer
•
The fan is equipped with an automatic timer which automatically turns the device of
f after the set time is over
.
•
One of the level buttons 1 / 2 / 3 must be pushed in the timer mode.
•
Adjust the desired time in the range of 0 - 120 minutes by turning the timer switch (10) clockwise.
The device switches of
f after the set time
is over
.
•
Put the timer switch on ON to switch on the device again.
GB GB
Pic. 2
11
1
7
16
15
14
13
12
11
. Base part
12. Back pedestal part 13. Cable guide 14. Cable support 15. Phillips screw (cable support) 16. Opening for pedestal fastening 17. Front pedestal part 18. Phillips screw (pedestal fastening)
18