2 tearing paper, 1 initial power up and self-test, S4500ths user guide portable printing solutions – Extech Instruments S4500THS User Manual
Page 11

7
S4500THS User Guide
Portable Printing Solutions
Extech Instruments Corporation 285 Bear Hill Road, Waltham, MA 02451-1064 Phone: 1-877-4-EXTECH (439-8324) Fax: (781) 890-7864 Web site: www.extech.com
Copyright © 2005 Extech Instruments Corporation. All rights reserved including the right of reproduction in whole or in part in any form.
2.2 T
EARING
P
APER
:
The printer’s paper door acts as a tear bar. Pull one edge of the paper
against the tear bar as indicated, then tear down and across against the
tear bar to tear the paper.
Caution: The tear bar may have sharp edges.
Using the tear bar is the only way to tear the paper.
Pulling up and pulling sideways without using the tear bar can
cause a paper jam due to paper misalignment in the
print head mechanism
F
IGURE
4: T
EARING
P
APER
3. U
SING
THE
P
RINTER
3.1 I
NITIAL
POWER
UP
AND
SELF
-
TEST
Once the Battery is charged and the paper is loaded perform a self-test:
Press the
green, blue or orange depending on the mode of communication.
The printer will stay ON until it is manually tuned OFF.
If the printer is set for infrared communications (IrDA) mode the printer will
stay on all the time. Pressing the
printer off.
Press the
To start the self-test, press and hold the
The printer starts to print the self-test message. Release the
Press the
The first few lines of self-test Figure 5 show the printer firmware version, the
current printer settings (for example IrDA or Serial mode) and a list of any
optional or special features installed.