Precision Digital PD6870 - Manual (Page 8)

PD6870 Loop-Powered Process Meter Instruction Manual
8
Electromagnetic Compatibility
EMISSIONS EN 61326:2006
Safety requirements for measurement, control, and
laboratory use
– Industrial
Group 1 Class A ISM emissions requirements
Radiated
Emissions Class A
IMMUNITY EN 61326:2006
Safety requirements for measurement, control, and
laboratory use
ESD ±4 kV contact,
±8 kV air
RFI
– Amplitude
Modulated
80-1000 MHz @ 10 V/m,
1.4-2.0 GHz @ 3 V/m,
2.0-2.7 GHz @ 1 V/m,
80% AM (1 kHz)
EFT ±2 kV DC mains, ±1 kV other
Telco Surge ±1 kV
CRFI 3 V, 0.15-80 MHz, 1 kHz 80% AM
SAFETY INFORMATION
WARNINGS

Read complete instructions prior to installation and operation of the meter.

Installation and service should be performed only by trained service
personnel. Service requiring replacement of internal components must be
performed at the factory.

Disconnect from supply before opening enclosure. Keep cover tight while
circuits are alive. Conduit seals must be installed within 18" (450mm) of
the enclosure.

Verify that the operating atmosphere of the meter is consistent with the
appropriate hazardous locations certifications.

If the meter is installed in a high voltage environment and a fault or
installation error occurs, high voltage may be present on any lead