MVVS 26 IFS - Manual (Page 2)

WARNING!
– Use the ignition only in dry conditions,
– use recommended number and type of cells for every ignition type,
– the product is specified for RC engines only (other use must be approved by the
manufacturer),
– do not take off the resister cover if the ignition is on,
– danger of electric injury (voltage over 20 000 V),
– recharge ignition battery only outside the model,
– because of possible interferences, ignition and battery should be placed
at least 25 cm from the receiver!
The manufacturer is not responsible for damages caused by not following the manual and misuse the ignition other than in RC engines!
You will lost your guarantee if you damage the high voltage (HV) cable or HV isolation, pickup, reverse the batteries or open ignition box!
Type Problem Solution
- fast blinking
(after power up)
battery test is
running
Wait a while.
- fast blinking
(5 sec after power up)
battery voltage
is low
Charge battery. Voltage is lower
than 6,5 V.
- one short flash
per second
sleep mode
spark is
blocked
Unplug battery and reconnect
it again.
PROGRAMMING SEQUENCE – CHANGING A SILENCER
PRODUCER:
MSR Engines s.r.o.
Nálepkova 97
637 00 Brno / Czech
fax.: +420 545 210 903
e-mail: [email protected]
www.msrengines.eu
– plug boot to plug,
– plug a battery to the ignition and power it up ,
– wait cca 90 sec until sleep mode is active. Led will start flashing shortly once
per second,
– if battery test is enabled (jumper is plugged) remove the jumper from program-
ming pins,
– wait cca 3 sec, a flashing sequence changes itself,
– unplug battery,
– plug jumper back (to enable battery test),
– if battery test is disabled (jumper is removed) plug the jumper to programming
pins,
– wait cca 3 sec, a flashing sequence changes itself,
– unplug battery,
– unplug jumper back (to disable battery test).
To change silencer type to the opposite, repeat whole procedure again (short -> long -> short).
Low battery
Sleep mode
Short silencer
Long silencer
0 100 ms 200 ms 300 ms 400 ms 500 ms 600 ms 700 ms 800 ms 900 ms 1 s 1.1 s 1.2 s 1.3 s 1.4 s
LED BLINKING TYPES
light
dark
LED BLINKING INDICATION
ICU-L ver 2_0 EN.indd 2 4.10.2011 20:35:38