Extron electronic DXP 44 SDI - Manual

Specifications — DXP 44 SDI, DXP 88 SDI
Video
Routing
DXP 44 SDI ....................... 4 x 4 matrix
DXP 88 SDI ....................... 8 x 8 matrix
Data rates ...................................... 143 Mbps, 177 Mbps, 270 Mbps, 360 Mbps
Auto data rate lock ...................... Yes
Standard ........................................ SMPTE 259M
Data types ..................................... 8 bit or 10 bit
Video input
Number/signal type
DXP 44 SDI ....................... 4 SDI serial digital video (8 or 10 bit SMPTE 259 M widescreen 16:9, component
4:2:2, and composite video) inputs, and
4 buffered loop-throughs
DXP 88 SDI ....................... 8 SDI serial digital video (8 or 10 bit SMPTE 259 M widescreen 16:9, component
4:2:2, and composite video), and
8 buffered loop-throughs
Connectors
DXP 44 SDI ....................... 4 female BNC for input, 4 female BNC for loop-through
DXP 88 SDI ....................... 8 female BNC for input, 8 female BNC for loop-through
Input cable equalization ............. 1 to 300 m for data rates up to 270 Mbps
1 to 200 m for data rates up to 360 Mbps
Auto equalization ........................ Yes
Input return loss .......................... >15 dB, 5 MHz to 270 MHz
Recommended cable type .......... Extron SHR or equivalent
Impedance .................................... 75 ohm
External sync (genlock) ............... 0.3 V to 0.4 Vp-p
Video output
Number/signal type
DXP 44 SDI ....................... 4 dual SDI serial digital video (SMPTE 259 M widescreen 16:9, component 4:2:2,
and composite video)
DXP 88 SDI ....................... 8 dual SDI serial digital video (SMPTE 259 M widescreen 16:9, component 4:2:2,
and composite video)
Connectors
DXP 44 SDI ....................... 4 x 2 BNC female
DXP 88 SDI ....................... 8 x 2 BNC female
Number of outputs per channel .. 2 outputs per channel
Nominal level ............................... 0.8 V ±10%
Impedance .................................... 75 ohms
Return loss .................................... >40 dB @ 5 MHz
DC offset ....................................... ±500 mV maximum with input at 0 offset
Jitter ............................................... <0.2 µs p-p
DC offset (termin. @ 75 ohms) ... 0.5 V (±)
Rise and fall time (20-80%) ......... 0.6 ns = 100 ps
Control/remote — switcher
Serial control port ........................ RS-232 or RS-422, 9-pin female D connector
Baud rate and protocol ............... 9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configurations 2 = TX, 3 = RX, 5 = GND
Program control ........................... Extron’s control/configuration program for Windows
®
Extron’s Simple Instruction Set (SIS ™ )
1-2 Digital XPoint Matrix Switchers • Specifications