Meliconi AT49 LTE - Manual (Page 3)

4
C
D
If the quality of the image is poor or if no signal is received, proceed as follows to improve
reception:
- increase/decrease
amplifi cation using the knob on the side of the antenna, bearing in mind
that maximum amplifi cation does not necessarily correspond to optimum signal quality. To
increase/decrease the level of amplifi cation turn the knob as shown on the symbol located
next to the knob.
- Change the position of the antenna.
- Turn or tilt the antenna receiver until reception improves.
NOTE: If you live near a TV station antenna to avoid image interference lower the central
antenna and turn down the amplifi cation level.
Improving reception
- If the antenna is not working make sure it is powered up correctly (blue LED ON) and that the
adjustment knob is in the maximum gain position.
Troubleshooting
2 YEAR WARRANTY - The warranty is declared null and void if the product is tampered with
or used improperly.
FEATURES AND TECHNICAL SPECIFICATIONS
- Indoor
amplifi ed digital antenna
- 230 Vac 50 Hz mains power input via an adapter included with the antenna
- 12 Vdc 100 mA power input socket for use on caravan, boat or campsite
- 5 Vdc 50 mA power input (via antenna connection) from decoder (if decoder includes this option)
- Reception of digital terrestrial TV signals (DVB-T), DAB radio signals and analogue TV
signals on UHF and VHF (band III) bands.
- Reception range: VHF + UHF (174~230 470~790 MHz)
- 4G LTE interference fi lter
- Very low noise emission amplifi er (< 1 dB)
- Antenna amplifi cation adjustment up to 49 dB
PACKAGE CONTENTS
- Antenna
- Instruction booklet
- 1.5 m long IEC-plug to IEC-plug coaxial cable
- AC/DC power supply unit
WARNINGS
- Keep away from water: the antenna must not be exposed to drips or water spray. Do not use
in a damp atmosphere.
- Only use the power supply unit supplied with the device.
- The power supply unit must be easily accessible to enable the electric separation of the
device from the network.
- The product complies with directive 2011/65/EU concerning restrictions on the use of
hazardous substances (RoHS II) in electric and electronic equipment.
- The product complies with the new low voltage (LVD) directive 2006/95/EC, the EMC
directive 2004/108/EC and the ErP directive 2009/125/EC.