Meliconi AD 40 Sail - Manual (Page 2)

3
GB
INDOOR AMPLIFIED
DIGITAL TERRESTRIAL SIGNAL ANTENNA
AD-40 Sail
USER INSTRUCTIONS
Thank you for choosing MELICONI.
The AD-40 Sail indoor amplifi ed antenna receives standard and HD digital terrestrial TV
signals and DAB radio signals on the UHF and VHF (band III) band. Moreover, thanks to
its built-in 4G LTE / GSM fi lters, the antenna is also protected against interference from
unwanted signals.
If possible, position the antenna near a window or outer wall and at a safe distance
from metal objects, electrical equipment and reinforced concrete walls to ensure optimum
reception.
A
Positioning the antenna
The AD-40 Sail is designed to receive digital signals – using a standard and HD digital
terrestrial decoder or a TV with built-in digital tuner.
- Make sure that the TV and the decoder are switched off before making any connections.
- Connect the Meliconi antenna cable to the socket at the back of the digital terrestrial
decoder or the television (fi gure 1). If the antenna socket on the decoder is of the F
socket type, use an F-plug to IEC-socket adapter (not included).
- Use the AC/DC adapter included in the kit to power up the antenna. Insert the cable
in the antenna power supply input and connect the adapter to the mains power supply
(fi gure 2).
- Turn the antenna ON by pressing the ON/OFF button located on the power feeder plug
and turn the knob at the back of the antenna to adjust gain.
- Check that the red LED on the front of the antenna is switched ON. This means that
the antenna is powered up correctly.
- Switch ON the digital terrestrial decoder and the television and select the channel
required. If necessary tune the antenna to suit the TV or decoder, as instructed in the
relative appliance manual.
B
Installation