Meliconi Gumbody Facile Smart - Manual (Page 3)

N.B. THE LIGHT INDICATOR STOPS FLASHING.
The remote control exits programming mode and the light indicator stops flashing:
• if no keys are pressed for 14 seconds
• if an invalid brand code is entered
• if the end of the code search list has been reached. In this case, consult our website www.meliconi.com/guide
3
GLOBAL SEARCH REMOTE CONTROL PROGRAMMING
This operation can take up to 20 minutes and should be carried out if you have not succeeded in programming
the remote control by means of the method described above.
The quickest and easiest way to programme the remote control is
by consulting the website www.meliconi.com/guide .
To display and make a note of the code memorized by means of the search,
follow the instructions described in the paragraph CURRENT CODE DISPLAY.
1. Switch on the TV.
2. Hold down the MUTE and ON/OFF keys together for 5
seconds until the light indicator starts to flash indicating
that the remote control is being programmed.
3. Release the keys and enter the code 0000 within 12
seconds. The light indicator flashes more quickly to indicate
that the remote control is ready for the search.
4. Point the remote control at the TV. Press and slowly release
the ON/OFF key several times, stopping when the TV
goes off.
5. When the TV goes off, press the OK key to confirm.
Three flashes indicate that the operation has been
completed correctly.
ADDITIONAL CHECK
Check that some of the other functions used on your original remote control are working correctly. If the
commands function incorrectly or erratically, you have probably entered a code for a similar remote control
but not the right one. In this case, repeat the search procedure starting from point 2.
N.B. THE LIGHT INDICATOR STOPS FLASHING.
The remote control exits programming mode and the light indicator stops flashing:
• if no keys are pressed for 14 seconds
• if the end of the code search list has been reached. In this case, consult our website www.meliconi.com/guide
+ 5 SEC.
+ + +