Meliconi Gumbody Facile 1 web - Manual (Page 3)

8
NOTE: If you don’t receive an SMS on your cell phone or if the message says ERROR / NO CODE, it
means the system has not been able to process the data you have sent. Do not try sending another
SMS use the MANUAL SEARCH instead.
When the device reacts check whether the other buttons are operating correctly too.
If they do, the remote control is ready to use.
If they don’t, you are probably using an incorrect code destined for a very similar device; at this point
ignore the SMS list and consult the MANUAL CODE section to fi nd a more suitable code.
SETTING CODES USING A MANUAL SEARCH
(only to be performed if the specifi c code could not be found)
CHECK
Check that the other buttons correspond to the functions of the original remote control; if not, it is likely
that the code found is incorrect, but is used for a very similar device. In that case, repeat the procedure
from point 2.
If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN
USE procedure and make a note of it inside the battery cover.
NOTE: During the search the indicator stops fl ashing and the remote control exits the programming mode
in the following cases:
• if for 12 seconds the button indicated is not pressed or if another button is pressed
• if the list of codes to fi nd is terminated. If this happens, go to the www.meliconi.com website
1. Switch on the TV and select a programme.
2. Press and hold down the ON / OFF and MUTE buttons
simultaneously for 6 seconds.
3. Release the buttons. The indicator light will fl ash. Point
the remote control at the device and press the ON/OFF
button. If the TV does NOT switch off, press the same
button again slowly (it may be necessary to press the
button several times).
4. When the TV responds correctly, press OK. Three long
fl ashes indicate that the operation has been carried out
correctly.
6 SEC. and