Fig.1, P1 p4 – Medal Sports FH1454818 User Manual
Page 7
FIG.1
3. Attach two pre-assembled Legs (#6) to the end of Hockey Mainframe (#5) using four Bolts (#A2) and four Washers
(#A3) per Leg.
See FIG. 1.
4. Attach the other two pre-assembled Legs (#6) to the other end of Hockey Mainframe (#5) but using only two
Bolts (#A2) and two Washers (#A3) on the sides of each Leg.
See FIG. 1.
Note: Please do not use any screws on the holes in the end apron of Hockey at this step. The Butterfly
Bolts (#A11) will be added later for the crooked Pole (#26). See FIG. 9A.
5.
Screw the Leg Levelers (#51) into the bottom of each leg.
6. Attach the Motor (#52) to the Hockey Frame (#5) using two Screws (#A10).
7. Lift the table assembly from the floor with two strong adults, turn it over, and set table on its legs in the location
where you play.
See FIG. 1A.
Go back and make sure that all connections are tight.
www.themdsports.com
1454818
6
(Continued on the next page.)
FIG. 1
5
6
P4
A2
A2
6
5
51
6
6
6
A3
A3
P1
P7
This is the hole for
Rivet Plug (#38).
No Bolts
Screwed
At This Time
P4
52
A10
P5
P6
FIG. 1A
X 4
P7
5
6
51
X 1
X 4
X 4
A2
X 12
A3
X 12
52
X 1
P1
P4
X 16
X 6
P5
X 2
P6
X 4
A10
X 2
DO NOT LEAN THE
TABLE ON ITS LEGS
HOLD TABLE
CABINET
DO NOT HOLD THE LEGS
CAUTION: Two strong adults are recommended to turn the table over as shown.
1. Lift the table off the ground.
2. Turn the table over.
3. Place it on all four feet at the same time on the ground.