Medal Sports BL54813 - Manual (Page 6)

FIG.1
FIG. 1
5
ASSEMBLY INSTRUCTIONS:
DO NOT LEAN THE
TABLE ON ITS LEGS
HOLD TABLE
CABINET
DO NOT HOLD THE LEGS
CAUTION: Two strong adults are recommended to turn the table
over as shown.
1. Lift the table off the ground.
2. Turn the table over.
3. Place it on all four feet at the same time on the ground.
1. Find a clean, level place to begin the assembly of your Combo Table. The table will be assembled
upside down and then turned over on its legs once the assembly completed. This game table is heavy,
and turning it over will require at least two strong adults.
2. Remove all the parts from the box and verify that you have all of the listed parts as shown on the parts list
page. Carefully cut or tear the four corners of the box so that the bottom of the box can be used as your
work surface.
X 2
X 1 1
4
X 2
X 2 5
6
X 16
X 16 A2
A3
X 8 A4
X 4 8
3. Attach the Legs (#4 and #5) to the Billiard Cabinet(#1) using four Bolts (#A2) and four Washers (#A3)
per leg. See FIG. 1.
4. Attach the End Leg Braces (#6) to the Legs using four Screws (#A4) per End Leg Brace.
5. Screw the Leg Levelers (#8) into the bottom of each leg.
6. Lift the table assembly from the floor with two strong adults, turn it over, and set table on its legs in the
location where you play.
Go back and make sure that all connections are tight.
1
4
5
&
P4
P1
1
4
5
A2
A3
A2
A3
8
P1
A4
4
5
6
P2
P4