Medal Sports BL58410 - Manual (Page 10)

ELECTRONIC SCORER OPERATION
9
Install Batteries
Battery Box: Unscrew bolt using a screwdriver and open the battery box. Insert 3 “AAA” batteries ( not included) in
the order of polarity as shown on the inside cover. Then close the cover using a screwdriver. Turn the power ON
using the ON/OFF switch.
Reminding:
a. Batteries must be installed according to the correct polarization (+ and -) requires.
b. Please clean the battery contacts and also those of the devices prior to battery installation.
c. If the game will not be used for a long period of time, we recommend that the batteries should be removed.
How to play
1. While game is in Sleep Mode, if a basketball is scored, the game will turn back on and the score board will begin
the 5 sec. countdown.
2. After finishing the game, Turn OFF the scorer by using the ON/OFF switch. NOTE: The scoreboard will turn off
after 5 minutes, if not in use, however, we recommend turning the ON/OFF switch to OFF when the game will not
be used for an extended period of time.
WARNING: !
1) Requires 3 “AAA” batteries (not included).
2) Do not mix old and new batteries.
3) Do not mix alkaline, standard (carbon zinc), or rechangeable (nickel-cadmium) batteries.
WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
YOU ARE NOW READY TO PLAY!
A2 A2
OFF/ON
RIGHT
LEFT