Introduction to shortwave – Eton G1000A User Manual
Page 13
13
G1000A
OPERATION MANUAL
INTRODUCTION TO SHORTWAVE
continued
BAND
MEGAHERTZ (MHz)
KILOHERTZ (KHz)
G1000A’S
(as on the G1000A) (as in most broadcast)
switch setting
49 meters
5.950-6.20 MHz
5950- 6200 KHz
SW1
41 meters
7.10-7.60 MHz
7100- 7600 KHz
SW2
31 meters
9.20-9.90 MHz
9500- 9900 KHz
SW3
25 meters
11.600-12.200 MHz
11600-12100 KHz
SW4
22 meters
13.570-13.870 MHz
13570-13870 KHz
SW5
19 meters
15.10-15.80 MHz
15100-15800 KHz
SW6
16 meters
17.480-17.90 MHz
17480-17900 KHz
SW7
13 meters
21.450-21.850 MHz
21450-21850 KHz
SW8
DAY BANDS / NIGHT BANDS – THE DIFFERENCE
IS VERY IMPORTANT
Because shortwave signals depend on such factors as the sun, the
ionosphere and interaction with the earth itself, signals cannot be
heard on all bands throughout the day. Some bands are best during
the daylight hours, and some are best at night. Here are some good
‘rules of thumb’.
• In general, the bands with frequencies below 13000 KHz are better
at night and the bands with frequencies above 13000 KHz are best
during the day. This guideline is not ‘cast in concrete’ but is a useful
general rule of thumb.
• Around sunrise and sunset, both the day and night bands might
be good, sometimes exceptionally good.
• In the summer time, the day bands often are good into the
early night.
• While most shortwave stations are found within the frequency
limits of these defined bands, some are found outside of them.
It pays to take the time to tune in-between bands too.
• These guidelines can be used worldwide and are not dependent
on location.