Medal Sports SH16602 - Manual (Page 6)

5
Assembly Instructions
FIG.1
8
2
4
3
7
7
1
13
1. Find a clean, level place to begin the assembly of your Air Hockey Table. The table will be assembled upside
down and then turned over on its legs once the assembly completed. This game table is heavy, and turning it
over will require at least two adults.
2. Remove all the parts from the box and verify that you have all of the listed parts as shown on the parts list
below. Carefully cut or tear the four corners of the box so that the bottom of the box can be used as your
work surface.
3. Attach the Leg Panel (#4) to the legs using four Screws (#8) per Leg Panel.
4. Place the Main Frame (#1) face down on a clean and flat surface. Attach the Right Leg (#2) and Left Leg (#3) to
the Main Frame using three Bolts (#7) per Leg. See FIG.1.
5. Screw Leg Leveler (#13) into each leg. See FIG.1.
6. Lift the table assembly from the floor with two adults, turn it over, and set table on its leg in the location where you
will play. Go back and make sure that all connections are tight.
HOLD TABLE
CABINET DO NOT
HOLD THE
LEGS
DO NOT LEAN THE
TABLE ON ITS LEGS!
CAUTION: Two strong adults are recommended to turn the table over as shown.
1. Lift the table off the ground.
2. Turn the table over.
3. Place it on all four feet at the same time on the ground.
2A
2A
21