Hotpoint Ariston SL C10 BCH - Manual (Page 17)

17
it en
Do not start the vacuum cleaner if the plastic
flexible hose is entangled, as this could
damage the appliance.
FEATURES
Electronic power regulator (B)
The electronic power regulator (26) (if available) al-
lows to set the suction power required.
On some models, the ideal power levels are indica-
ted, according to the surface to be cleaned: awnings,
carpets and hard floors.
The Eco function (if available) allows to save 25%
energy, compared with the consumption relative to
max suction power, ensuring at the same time clea-
ning efficacy.
Remote Power Control (C)
The Remote power control (if available) enables you
to adjust the suction power directly and effortlessly
from the hand grip, with no need to bend. When using
the vacuum cleaner, you can keep it on standby by
pressing the Start & Pause button (22).
To insert or change the batteries of your Remote
Power Control:
1. Open the battery compartment (23).
2. Insert two AAA batteries, making sure of the
positive and negative poles.
3. Close the battery compartment until it clicks into
place.
Trolley System (D)
The Trolley System allows you to move your vacuum
cleaner easily when cleaning and carry it from room
to room effortlessly.
1. Press the opening/closing button on the Trolley
System (13) to pull out the carry handle (12) until
it locks into place at the desired length.
2. Having completed your cleaning, press the
opening/closing button on the Trolley System
and close the carrying handle until it locks into
place.
Use the Trolley System's carrying handle to
store the appliance, making sure you have
correctly locked it into place.
Start & Pause (E)
The Start & Pause function (if available) allows you
to keep the vacuum cleaner on stand-by and lock
the cleaning head in the park position: just insert the
brush into its horizontal housing (30).
USING
THE VACUUM CLEANER (A)
The appliance is equipped with a safety
device that prevents the dust-compartment
lid from closing unless the dust bag has been
correctly installed. Do not force the dust bag lid to
close and make sure all the parts are in the correct
position to allow you to close the lid.
Do not use the vacuum cleaner without
filters, Pure Clean dust bag, dust bag support
or dust container, as the appliance could get
damaged.
1. Unwind the power cord (34) and plug the
appliance into an electrical outlet (220/240V).
We advise you to unwind the entire power
cord (yellow marker: 6,5m; red marker: 7m)
to avoid any overheating and damage.
2. Press the start/stop button (19) to start the
appliance.
3. Press the Trolley System opening/closing
button (13) to extend the carrying handle (12)
to the desired length until it locks into place.
Then manoeuvre the vacuum cleaner using the
carrying handle when cleaning the house.
4. To select the desired suction intensity
(based on the model) use the +/- button
and electronically adjust the power (21) of
the Remote Power Control; or manually
rotate the electronic power regulator (26).
We advise you to use a low suction power
on delicate surfaces such as curtains,
fabrics, cushions etc to avoid any damage; or at
least open the air regulator to reduce the suction
effect.
5. To pause the vacuum cleaner, if this feature is
available, you can use the standby button (22)
on the Remote Power Control or the Start & Stop
function (based on the model). Just insert the
brush into its horizontal housing (30).
6. To switch off the appliance press the start/stop
button again.
7. Disconnect the plug from the electrical
outlet and press the cord-rewind
button (20) until rewinding is complete.
Make sure the cord does not get entangled
during rewinding.
8. Secure the floor head into its horizontal / vertical
housing and store the appliance.