Powerfix Z31697B - Manual (Page 10)

10 GB
Switching on and off /
Automatic shut-down
Briefly press the ON/OFF button 4 to
switch the device on or off.
Note: If you do not press any button for one
minute after the device has been switched on,
the device automatically switches off.
Start-up
Briefly press the ON/OFF button 4 to
switch the device on (Fig. A). A selection of
menu points appears at the bottom of the
display
2 :
(Fig. A)
The selection arrow (▼) 10 is over the menu
point for Beam search (STUD) 14 , when the
device is switched on. Bring the selection
arrow over the desired menu point by repeat-
edly pressing the selection button (►)
3 . The
meaning of the individual menu points are:
; Wooden beam search
: Metal search
: Void search
: Power line search
Guide the detector over a location on the
surface to be examined, where you know that
there is no object, which you are looking for.
Then press the PUSH button
5 and keep it
pressed down. Guide the detector, with the
underside flat, over the surface to be exam-
ined. It is possible that during this some short
signal tones may sound. These are however
without any meaning, so long as no intensity