Powerfix PDM 250 A1 - Manual (Page 12)

POWERFIX PDM 250 A1
10 - English
Inserting/changing the battery
The multimeter is powered by a 9V battery. To insert or replace the battery, proceed as follows:
Switch off the multimeter and remove all test leads before opening the multimeter!
If the battery is exhausted, the icon appears on the display [1]. The battery should be
replaced as soon as possible to ensure that the multimeter continues to work properly.
 Remove the holster [2].
 Remove the two screws on the back of the multimeter and remove the back panel.
 Connect the 9V battery with the correct polarity (note + and –) to the battery clip and place
the 9V battery in the battery compartment.
 Replace the back panel and screw it tight with the two screws.
 Re-insert the multimeter in the holster [2].