Powerfix Z22855 - Manual (Page 6)

GB 8
Avoid contact with skin, eyes, and mucous membranes. If you
come into contact with battery acid, rinse the affected spot
with plenty of water and / or consult a doctor immediately!
WARNING! Switch the product OFF before inserting
the battery (LCD display 5 is off.)
Remove the battery from the device if it is not in use for a
long period of time.
Do not, on any account, short-circuit the terminals.
Before start of operation
Insert / replace battery
Tip: Flashing numbers indicate a discharged / flat battery.
Tip: When changing the battery, the LCD display
5 may
experience faults. Remove the battery and insert it again after
waiting more then 30 seconds.
Push open the lid to the battery compartment 8 (see Fig. B).
Remove the old battery.
Insert the new battery into the battery compartment and
ensure correct polarity (+ and –). Make sure that the plus
terminal points outwards.
Push the lid to the battery compartment 8 shut again
(see Fig. B).
Preparing the ca
ůů
iper
Loosen the locking screw 4 so that you can move the
Clean all measuring surfaces and the
9999999999 99rod. Otherwise,
faulty measuring results may occur due to, for example,
humidity.
Check that all keys, switches and the LCD display 5 work
correctly.
Starting up the device
Using the ca
ůů
iper
Loosen the locking screw 4 by turning it anti-clockwise.
Push the external measuring jaws 11 and the internal meas-
uring jaws 2 together.
Switch the LCD display 5 on by pressing the ON / OFF key 10 .
Press the inch / mm key 3 to set the unit of measurement
(inch or mm) you wish to use. Either “mm” or “inch” will
appear to the right of the figures in the LCD display
5 .
Press the key to obtain the zero setting (ZERO) 9 in order
to reset the LCD display 5 to zero.
Measuring an object from the outside:
Move the external measuring jaws 11 apart by turning the
handwheel 7 outwards anti-clockwise.
Place the external measuring jaws 11 against the object to
be measured.
alliperJ
alliper