Silvercrest SBT 3.6 A1 - Manual (Page 45)

42 SBT 3.6 A1
GB
7) If a lot of hair has accumulated in the precision comb 8, remove the comb and
blow or shake the hair out.
8) When you are fi nished with the treatment, push the on/off switch w in the opposite
direction to switch off the appliance.
Shaping with the precision trimmer
To give the bikini line its own form, use the precision trimmer 6 without the precision
comb 8.
1) Start by removing the precision comb 8 from the precision trimmer 6 or fi t the
precision trimmer 6 on the hand element q.
2) Push the on/off switch w in the direction of the attachment.
3) Use the appliance to contour your bikini line as required. Push the precision trimmer 6
gently against the hair. You can use the precision trimmer 6 directly on the skin or
stroke the outer part of the attachment housing across the skin. Let your creativity
run free or use one of the enclosed trimming templates o to create a contour.
4) When you are fi nished with the treatment, push the on/off switch w in the opposite
direction to switch off the appliance.
Trimming eyebrows with the precision trimmer and
eyebrow comb
You can use the precision trimmer 6 and the eyebrow comb 4 to trim your eyebrows
to the same length.
1) Start by removing any other attachment from the hand element q, if required.
Fit the precision trimmer attachment 6 onto the hand element q so that the two
grooves in the attachment match up with those on the back of the hand element q.
2) Push the eyebrow comb 4 with its side rails onto the two grooves on the appliance
until it clicks into place.
3) You can vary the cutting length to any one of the three settings. To do this, press
on the grooved area 5 on the eyebrow comb 4 so that the locking catch 0 is
pushed into the housing. Then push the eyebrow comb 4 to the cutting length
position which corresponds to the desired length. Use the cutting settings on the
eyebrow comb 4 as an orientation aid as well as the following table:
Setting Hair length after cutting
1 approx. 3 mm
2 approx. 6 mm
3 approx. 9 mm
4) Push the on/off switch w in the direction of the attachment.
IB_95827_SBT3.6A1_LB2.indb 42 26.09.14 13:22