Silvercrest SMFB 2.1 A1 - Manual (Page 50)

46 SMFB 2.1 A1
GB
MT
5) Place two of the Velcro fastening points 23 inside the helmet to attach the
speakers 9 . Ensure that you attach these in a position that corresponds
to that of the ears of the person wearing the helmet. Remove the protective
fi lm from the rear of the Velcro fastening points
23 and affi x these in the
desired location.
NOTE
► If the lining of the helmet holds the speakers 9 even without the Velcro
fastening points 23 , then you will not need to use the Velcro fastening
points
23
.
6) Press the speakers 9 onto the Velcro fastening points
23
inside the helmet.
7) Push the cable a little way beneath the helmet padding if possible.
Fig. 1
Attaching the pillion unit to the helmet
Install the pillion unit in the helmet (see Fig. 1):
1) Place the Velco fastening point for the pillion unit 25 into the helmet so that
the microphone 17 is pointing forwards. Remove the protective fi lm from
the rear of the Velcro fastening point 25 and affi x it in the desired location.
Place two of the Velcro fastening points 23 inside the helmet to attach the
speakers 18 of the pillion unit. Ensure that these are attached in a position
that roughly corresponds to that of the ears of the person wearing the helmet.
Remove the protective fi lm from the rear of the Velcro fastening points
23
and affi x these in the desired locations.
2) Press the speakers 18 onto the Velcro fastening points 23 inside the helmet.
Press the pillion unit onto the Velcro point for the pillion unit 25 . Ensure that
the microphone 17 is pointing forwards.
3) Push the cable a little way beneath the helmet padding if possible.
IB_93846_SMFB2.1A1_LB5.indb 46 IB_93846_SMFB2.1A1_LB5.indb 46 02.12.13 09:30 02.12.13 09:30
145 mm x 205 mm