beautypg.com

Specifications, Model numbers systems, Model numbers – Exmark Lazer Z D-Series 920 User Manual

Page 17: Systems

background image

Specifications

Specifications

Model Numbers

Serial Nos: 920,000 and Higher

LZD25KD605; LZD25KD725

Systems

Engine

Engine Specifications: See your Engine Owner’s
Manual

Engine Oil Type: Exmark 4–Cycle Premium
Engine Oil

RPM: Full Speed: 3850 ±50 RPM (PTO not
engaged) Idle: 1400 ±100 RPM

Fuel System

Capacity: 15.5 gal. (58.6 L)

Type of Fuel: Diesel fuel, 40 cetane or higher or
biodiesel up to B20 (20% biodiesel, 80% petro
diesel).

Fuel Filter: In-line 113 Micron
Exmark P/N 112-7836.

Fuel Shut-Off Valve: 1/4 turn increments
(“OFF”, right tank, left tank, )

Fuel gauge in left hand fuel tank.

Electrical System

Charging System: External Alternator

Charging Capacity: 60 amps

Battery Type: BCI Group 26

Battery Voltage: 12 Volt

Polarity: Negative Ground

Fuses: One 20 amp blade type; One 30 amp blade
type

Safety Interlock System

PTO must be disengaged, brake engaged, and
motion control levers out (neutral lock) to start
engine. (It is not necessary for the operator to be
in the seat to start the engine.)

Operator must be in seat when PTO is engaged,
brake is disengaged, or motion control levers are
moved in or engine will stop.

Engine will stop if either the left, the right, or
both levers are moved from neutral lock position
while brake is engaged.

Engine Overheat Protection System

PTO will disengage, an alarm will sound, and the
coolant temperature gauge will be in the red area
when the engine temperature reaches an overheat
condition. The PTO will not re-engage until the
engine has cooled and the PTO switch is manually
shut-off and re-engaged.

Note: If the engine coolant level is below the
indicator line on the overflow bottle when the
engine is cold, the coolant temperature gauge may
not register correctly during operation and/or
the warning buzzer may not sound if the engine
overheats. Refer to Check Engine Coolant Level
in Maintenance.

Cooling System

Fan: Electric with continuous operation with
engine running.

Coolant Liquid: 50/50 mix of DexCool©
extended life antifreeze and water.

Coolant Capacity: 4 quarts

Operator Controls

Steering and Motion Control:

Note: Motion control levers are adjustable to
two heights.

– Separate levers, on each side of the console,

control speed and direction of travel of the
respective drive wheels.

– Steering is controlled by varying the position

of the levers relative to each other.

17

This manual is related to the following products: