Silvercrest SFR 36 A1 - Manual (Page 52)

50 GB
6.2 Switching on and off
Irrespective of the battery’s charging status,
the device can be used at any time in mains
operation.
1. In order to use the power pack, ensure
that the device is switched off.
2. Connect the plug-in power unit13 to
the socket8 on the device.
3. Insert the plug-in power unit13 in into
an easily accessible wall socket, the
voltage of which corresponds to the
rating plate.
4. Remove the protective lid10 before
switching on.
5. To switch on the device, push the on/
off switch6.
6. When switching on ...
… the display is lit blue,
… the charging state is shown,
… the lock symbol briefly appears on
the display7.
7. To switch off the device, push the on/off
switch6 again.
6.3 Transport lock
If the transport lock is activated, a lock sym-
bol appears on the display7.
• Press and hold the on/off switch6 for
approx. 3 seconds, in order to switch
the transport lock on/off.
• Connecting the plug-in power unit13
deactivates the transport lock, which
cannot be activated during mains op-
eration.
6.4 Shaving
DANGER! Risk of electric
shock!
• The hand-held device and the plug-in
power unit are not waterproof and are
therefore not allowed to be used in a
shower/bath.
WARNING!
• Do not use the device on open
wounds, cuts, sunburn or blisters.
• Do not place excessive pressure on the
shaving foils1. They are thin and can
be damaged easily.
NOTES:
• The device is suitable for both dry and
wet shaving (Wet & Dry).
• Initial use may cause temporary irritation
or redness of the skin, as the skin has to
adjust to shaving. This is normal and usu-
ally lasts between 2 and 4 weeks.
Dry shaving (Rechargeable bat-
tery and mains operation)
• Hold the device at a right angle to the
skin surface and gently guide it over
your face.
• Shave against the direction of your
beard growth.
• Stretch your skin in complicated areas,
such as the chin, to achieve better re-
sults.
• Switch off the device after shaving,
clean the parts carefully (chapter
"Cleaning and maintenance of the de-
vice" on page 51) and place the pro-
tective lid10 onto the shaving head3
to protect the shaving foils1 and the
long hair trimmer11.
__KRA100057_B1.book Seite 50 Montag, 26. Mai 2014 3:19 15