beautypg.com

Cleaning, 5 thermal cut-out, 6 frost protection – Silvercrest SKD 2300 A1 User Manual

Page 48

background image

46

6.5 Thermal cut-out

For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Switch the mains switch 9 to "0" to

switch off the appliance.

2. Check whether the air inlet 6 or outlet 4

is obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.

3. Wait for the appliance to cool down.
4. You can then continue to operate it

normally.

6.6 Frost protection

To prevent the temperature in a room falling
below 0 °C (32 °F), proceed as follows:
1. Press the button for selecting heating

level 25 repeatedly until "Frost
protection" symbol 13 appears in
display 5.

As soon as the temperature in the immediate
vicinity of the appliance drops significantly
below 7 °C (44 °F), the heating
automatically switches on.
As soon as the temperature rises to above
9 °C (48 °F), the heating switches off and
display 5 shows room temperature again.
2. To switch off frost protection, press the

button for selecting heating level 25
repeatedly until "Frost protection"
symbol 13 in display 5 disappears.

7. Cleaning

To ensure your appliance gives you lasting
service, you should clean it regularly.

Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before

each clean;

– allow the appliance to cool

down;

– never immerse the appliance in

water;

– never allow water or cleaning

agent to run into the appliance.

1. Carefully remove major dust deposits

from the protective guards with a
vacuum cleaner.

2. Remove any remaining dirt with a soft

brush.

3. Clean the outside of the appliance with

a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.

4. Wipe the appliance with a cloth

moistened with clear water.

5. Do not use the appliance again until it

has dried completely.

RP100058 Konvektor LB2 Seite 46 Mittwoch, 30. April 2014 4:30 16