Silvercrest SIKP 2000 B1 - Manual (Page 10)

8 GB
carries on cooling the appliance after it
has been switched off.
• After 120 minutes without a change in
setting, the appliance switches off auto-
matically. The cooling fan carries on
cooling the appliance after it has been
switched off.
8.3 Switching off with a
timer
1. Touch the symbol |9 during operation.
The control light|13 lights up, min ap-
pears above the display and on the dis-
play the chosen switch-off time appears
in minutes (presetting: 0 minutes, the de-
vice remains on).
2. Change the switch-off time by touching
the symbol |8 in one-minute steps and
by touching the symbol |7 in 10-min-
ute steps. If you have set the chosen time
and touch no further symbols, the timer
starts automatically and the display
switches over to W or °C again. At
short intervals, the remaining time is dis-
played together with min.
3. After the preset time has elapsed, the
appliance switches off. An acoustic sig-
nal sounds. The symbol -H- is shown in
the display, as the temperature of the
cooking zone is more than 60 °C. The
cooling fan carries on cooling the appli-
ance after it has been switched off.
8.4 Child safety lock
To prevent unwanted alteration of the set-
tings, the appliance is equipped with a child
safety lock.
NOTE: if the child safety lock is activated
while in operation, the symbols child safety
lock
|6 and on/off |5 are not blocked
and you can switch the device off. You will
only be able to switch the device on, once
the child safety lock has been deactivated.
• Touch the symbol child safety lock |6.
The control light for the child safety
lock|3 lights up and an acoustic signal
sounds. All symbols except the child
safety lock
|6 are now blocked.
• Touch the symbol child safety lock |6
for at least 4 seconds to override the
child safety lock. An acoustic signal
sounds and the control light for the child
safety lock|3 goes out. The symbols are
no longer blocked.
9. Cleaning
DANGER! Risk of electric shock!
• Pull the mains plug|1 out of the wall
socket before you clean the device.
• The induction hot plate, the power ca-
ble|1 and the mains plug|1 must not be
immersed in water or any other liquids.
DANGER! Risk of injury
through burning!
Allow the device to cool down be-
fore cleaning.
WARNING! Risk of material damage!
• Do not use any astringent or abrasive
cleaning agents.
• Clean the cooking zone|2 after every
use. In this way, you can prevent any ad-
hering food residues from burning on.
• Clean all surfaces and the power ca-
ble|1 with a slightly moistened cloth.
• Baked-on residues on the cooking
zone|2 can be removed with a ceramic
hob scraper, which may be purchased
at a department store.
__RP100060_Induktionskochplatte_B4.book Seite 8 Donnerstag, 13. Februar 2014 11:50 11