Before you start, Fitting the suction pads – Silvercrest SLS 2200 A1 User Manual
Page 47
SilverCrest SLS 2200 A1
English - 45
Before you start
Remove the solar battery charger and the accessories from the packaging.
Fitting the suction pads
Fix the four suctions pads (O) to the bottom of the solar battery charger as
shown in the diagram below. Insert the suction pads (O) into the hole. Next, fix
the suction pads (O) by sliding them into the smaller hole.
You can now mount the solar battery charger to a flat, even surface using the
suction pads.
The surface should be free of dust, oil and grease for the
suction pads to stick well.
See also other documents in the category Silvercrest Power suppliers:
- SUKL 1.2 A1 (22 pages)
- SUNL 1.2 A1 (9 pages)
- Z31306A (19 pages)
- Z31306B-BS (43 pages)
- Z31306B-BS, Z31306B-BS-W (33 pages)
- Z31306B-BS (43 pages)
- Z31306B-BS, Z31306B-BS-W (19 pages)
- UCM507 (31 pages)
- SLS 2000 B2 (60 pages)
- SLS 2000 B2 (74 pages)
- SLS 1000 A1 (72 pages)
- Z30833 A / Z30833B (64 pages)
- Z30833 A / Z30833B (85 pages)
- SLM 11 A1 (4 pages)
- SLM 11 A1 (4 pages)
- SLM 11 A1 (6 pages)
- KH 997 (74 pages)
- SLM 11 B2 (2 pages)
- SLM 11 B2 (2 pages)
- SLM 11 B2 (2 pages)
- SLM 11 B2 (2 pages)
- SLM 11 B2 (2 pages)
- SLM 11 B2 (2 pages)
- SLM 11 B2 (2 pages)
- SLM 11 B2 (2 pages)
- Z32144A-BS/ Z32144B-BS (14 pages)
- Z32144A-BS/ Z32144B-BS (42 pages)
- Z32144A-BS/ Z32144B-BS (41 pages)
- SLG 1.0 A1 (4 pages)
- SSB 1.0 A1 (4 pages)
- Z31306B-BS (34 pages)
- SLS 2200 B2 (90 pages)
- SLS 2200 B2 (106 pages)
- SLS 2200 B1 (106 pages)
- 106898-14-01 (2 pages)
- SPB 5.2 A1 (76 pages)
- SPB 5.2 A1 (108 pages)
- TLG 500 B1 (63 pages)
- SLS 2200 A1 (120 pages)