Charging 5 v devices, Troubleshooting – Silvercrest SBTF 10 C2 User Manual

Page 64

SBTF 10 C2

Rejection of a call

●

Press the multi-function button 6 for 3 seconds to
reject an incoming telephone call.

Adjusting the volume of the hands-free appliance

You can adjust the sound volume level of the hands free
device with the +/- buttons 3.

●

During a call, repeatedly press the + resp. - buttons 3
until the desired sound volume level is obtained. The
attainment of the maximum sound volume level is indi-
cated by a short signal tone.

Charging 5 V Devices

●

Check the max. input voltage (5V) and the max. power
input (1000 mA) of the device which you want to charge.
For this, consult the operating manual of the device.

●

Connect the device to be charged with the USB port 4
on the hands free device. The device now receives its
power supply from the hands free device. If the device
is equipped with a charging indicator light, this will in-
dicate that the device is being charged.

Note:

If the power supply does not activate automatically, you
should disconnect the USB cable from the USB port 4
and re-connect it.

Troubleshooting

If you cannot connect the hands-free appliance with a
compatible mobile telephone, proceed as follows:

●

Ensure that the Bluetooth

function in the mobile

telephone is activated.

●

Ensure that the hands-free appliance is correctly
installed, switched on and supplied with electricity.

●

If you use several Bluetooth

appliances, ensure that

a previously created Bluetooth

connection of the

mobile telephone is separated.

IB_93813_SBTF10C2_LB1.indb 61

10.10.13 09:40