Emerson Radio SB220 - Manual (Page 4)

3
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
• Avoid installing this unit in places exposed
to direct sunlight or close to heat radiating
appliance such as electric heaters, on top
of other stereo equipment that radiates
too much heat, places lacking ventilation
or dusty areas, places subject to constant
vibration and/or humid or moist areas.
• Store your CDs in a cool area to avoid
damage from heat.
IMPORTANT NOTES
• Do not attempt to clean this unit with
chemical solvents as this might damage
the finish. Use a clean dry cloth.
• Operate controls and switches as
described in the manual.
• Before turning on the power, make certain
that the connecting cords, if any, and
power cord are properly installed.
• When moving the set, be sure to first
disconnect the AC power cord.
CLASS 1 LASER PRODUCT
CLASS 1 LASER PRODUCT
APPAREIL Á LASER DE CLASSE 1
PRODUCTO LASER DE CLASE 1
CAUTION
INVISIBLE LASER RADIATION
WHEN OPEN AND INTERLOCKS
DEFEATED.
AVOID EXPOSURE TO BEAM
This product contains a low power Laser Device.
SB220_011305.p65 13/1/2005, 10:27 3