Silvercrest Z29852A/Z29852B - Manual (Page 8)

8 GB
Safety Instructions / Getting started
the event of contact with battery
acid, rinse the affected area
with plenty of clean water and
consult a doctor immediately.
Remove light dirt from the bat-
tery and product contacts with a
dry, non-fluffing cloth before
inserting the batteries.
Remove the battery from the
product if it is not in use for any
length of time.
Make sure that the polarity is correct
when you insert the battery. This
is indicated in the battery com-
partment. The battery can other-
wise explode.
Insert the battery with care.
The product can otherwise be
damaged.
Please do not dispose of used
batteries in your household
waste but take them to a desig-
nated collection depot for
special waste.
Q Getting started
1. Open the battery compartment 15 under the
scale by pushing the clip 7 on the battery
compartment cover 8 towards the battery
compartment and lift up the cover.
2. Remove the battery isolating strip 16 from under
the battery metal contact to which it is attached.
3. Place the battery compartment cover 8 back
on the battery compartment 15 . Ensure that the
two extensions 13 on the battery compartment
cover 8 fit into the two notches 14 on the
edge of the battery compartment opening
when the cover is closed. Press the battery
compartment cover 8 firmly on to the battery
compartment 15 until you hear it engage.
16 11
12
Q Replacing the battery
1. Switch off the scale. Press and hold down the
On / Off / Zero button 5 for 3 seconds.
2. Open the battery compartment 15 as described
above.
3. Remove the exhausted batteries from the battery
embedding case 11 by pressing the black bat-
tery locking tab 12 . The battery is automatically
released from the battery embedding case 11 .
Ensure that you do not exert too much force on
the contact
10 , otherwise it could be damaged
by over-bending as the battery is lifted. Remove
the battery from the battery embedding case
11 .
4. Insert a new battery into the battery embedding
case 11 . Make sure you fit the battery the right
way round (polarity). The “+”- side must face
upwards. The metal contact
10 presses battery
into position.
5. Close the battery compartment 15 as described
above.
Q Unit conversion button
j The unit conversion button 9 for the units of
weight can be found on the bottom of the kitchen
scale. By simply pressing the button the units of
measure change between metric (g, ml) and
imperial (lb:oz, fl’oz).
Note:
– If the units of weight are set to metric (g) then
the units of volume will be automatically shown
as ml.
96498_silv_Digitale_Kuechenwaage_Content_PL_HU_SI_CZ_SK.indd 8 18.11.13 16:07