Silvercrest SSM 550 C1 - Manual (Page 51)

- 48 -
Cleaning the mixer
➩
So that you do not injure yourself on the cut-
ters
r , clean the mixer jug e only with a long
handled dishwasher brush.
➩
In a case of stubborn soiling, the mixer jug e
can also be cleaned in a dishwasher. For this,
always take the mixer jug
e apart, as
described later.
➩
Clean the cover w and the filling cap q in a
dishwasher or with the normal washing up.
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
➩
Fill the mixer jug e with 750 ml of water and
add a few drops of mild detergent. Close the
cover
w and fit the mixer jug e onto the motor
block u .
Insert the plug into a mains power socket and
activate the Ice Crush/Clean operation a few ti-
mes, such that the cutter
r ploughs through the
water at full speed.
Afterwards, rinse the mixer jug
e out with lots of
clean water to ensure that all detergent residues
have been removed.
Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug
e (with the cut-
ters r ) from the the glass part of the mixer jug e :
Glass element
Sealing ring
Cutting blade
Plastic element
➩
Remove the mixer jug e from the motor block u .
➩
Turn the plastic element
of the mixer jug e
anti-clockwise, such that it allows itself to be relea-
sed from the glass element
of the mixer jug e .
Attention!
Take care with the cutting blades
. They are very
sharp. Risk of injury!
➩
Clean both parts thoroughly in a mild soapy
solution or in a dishwasher.
➩
Replace the plastic element
of the mixer jug e
back onto the glass element
. Ensure that the
sealing ring
is correctly fitted.
IB_96113_SSM550C1_DE_CH_NL.qxp 14.11.2013 14:20 Uhr Seite 48